Filter
Top Products
xiii
ATTO Technology Inc. FibreBridge Installation and Operation Manual
SCSIPortTermination
Configures/reports the SCSI internal termination of the
SCSI port identified on the FibreBridge.Enabling
termination allows the FibreBridge to act as a terminator
at the end of a SCSI chain.
Default: enabled
set SCSIPortTermination [sb] [enabled | disabled]
Requires a SaveConfiguration command
get SCSIPortTermination [sb]
SCSIPortWideTransfer
Specifies whether wide SCSI transfers should be
negotiated. Enabled allows wide transfer negotiation
Default: enabled
set SCSIPortWideTransfer [sb] [enabled | disabled ]
Requires a SaveConfiguration command
get SCSIPortWideTransfer
SCSITargetLUNs
Controls the maximum number of SCSI LUNs per target
the FibreBridge queries during a SCSI bus scan.
Default: 8
set SCSITargetLUNs [sb] [8 | 64]
Requires a SaveConfiguration command
get SCSITargetLUNs [sb]
SCSITargets
Lists the physical devices connected and running on the
specified SCSI port.
SCSITargets [sb]
SerialNumber
Reports the FibreBridge serial number. The serial
number, unique for each FibreBridge, is a 13-character
field. The first seven alphanumeric characters are an
abbreviation of the FibreBridge name while the
remaining six numbers are the individual FibreBridge
board’s number.
get SerialNumber
SerialPortBaudRate
Configures/reports the baud rate for the FibreBridge RS-
232 serial port or header. The number of data bits per
character is fixed at 8 with no parity. Choices are 9600,
19200, 38400, 57600 and 115200
Default: 115200
set SerialPortBaudRate [9600 |19200 |38400 | 57600
|115200]
Requires a SaveConfiguration Restart command
get SerialPortBaudRate
SerialPortEcho
Control/reports the status of the display of keyboard
input. When enabled, all non-control character keyboard
input is output to the display. Local ASCII terminal (or
terminal emulator) echo settings should be set to
disabled
while using
SerialPortEcho enabled
Default: enabled
set SerialPortEcho [enabled | disabled]
Requires a SaveConfiguration Restart command
get SerialPortEcho
SNMP
Controls whether or not SNMP functions on the
FibreBridge.
SNMP [enabled | disabled]
Default: enabled
SNMPDumpMIB
Displays the contents of the ATTO FibreBridge private
SNMP MIB to the current CLI session. Consult your
network administrator for further assistance with SNMP.
SNMPDumpMIB
SNMPExtendedTraps
Controls Extended SNMP trap functioning such as device
transition and device error. Consult your network
administrator for further assistance with SNMP.
Default: disabled
set SNMPExtendedTraps [enabled | disabled]
get SNMPExtendedTraps