Filter
Top Products
18
Mapping devices automatically
1 If you are not already in
the ExpressNAV
interface, type the IP
address of your
FibreBridge in a
standard browser as
found in
Using
ExpressNAV
on page
25, click
Enter Here,
type in your user name
and password, and click
OK.
1The
Status page
appears.
2 From the ExpressNAV
main menu, click on the
Mapping menu item on
the left side of the
screen.
3The
Mapping page
appears. Wait for the
automatic scan for devices to complete.
4 Click
AutoMap
All the commands necessary to enable
mapping and the command
saveconfiguration norestart are performed.
Mapping devices manually.
1 If you are not already in the ExpressNAV
interface, type the IP address of your
FibreBridge in a standard browser as found in
Using ExpressNAV
on page 25, click Enter
Here,
type in your user name and password,
and click
OK.
1The
Status page appears.
2 From the ExpressNAV main menu, click on the
Mapping menu item on the left side of the
screen.
3The
Mapping page appears. Wait for the
automatic scan for devices to complete.
4 Select the devices from the box on the right
hand side of the screen and drag to the
appropriate LUN on the left.
5 Click
Submit. All the commands necessary to
enable mapping and the command
saveconfiguration norestart are performed
Multiple Node addressing (FB2400 only)
The FibreBridge has a unique Port name for each
Fibre Channel port. By default, each Fibre
Channel port also has a separate unique Node
name: the host computer perceives the
FibreBridge as two separate entities, allowing
mapping of a different set of logical units to each
FC port.
You may use a combination of the Command
Line Interface and ExpressNAV to change the
default setting to create a single Node name for
the FibreBridge and map devices to that node.
1 Connect to the FibreBridge using the
Command Line Interface as described in
Interface options
on page 25.
2 At the
Ready prompt, type
set FCMultiNode disabled
Note
Changing the state of the
FCMultiNode
command causes all maps to be deleted.
3Press Enter.
4Type
saveconfiguration restart.
5Press Enter.
6 Follow the directions in
Mapping devices
automatically
or
Mapping devices manually.
above.