Filter
Top Products
TMA; Reviewed:
SPOC 7/21/2008
Solution & Interoperability Test Lab Application Notes
©2008 Avaya Inc. All Rights Reserved.
14 of 21
ProCurve-ACM
6. Create and configure the data VLAN that will run in Lab-A.
• Assign a VLAN ID for the data VLAN.
• Assign a name for the data VLAN.
• Assign an IP address for the data VLAN.
• Set an IP helper address for DHCP.
• Assign ports to the data VLAN.
ProCurve Switch 3500yl-24G-PWR# configure
ProCurve Switch 3500yl-24G-PWR(config)# vlan 30
ProCurve Switch 3500yl-24G-PWR (vlan-30)#vlan 30 name Datavlan2
ProCurve Switch 3500yl-24G-PWR (vlan-30)#ip address 192.168.30.254/24
ProCurve Switch 3500yl-24G-PWR (vlan-30)# ip helper-address 10.20.20.250
ProCurve Switch 3500yl-24G-PWR (vlan-30)# untagged 3-4,13
ProCurve Switch 3500yl-24G-PWR (vlan-30)# exit
7. Save the running configuration to the startup configuration.
ProCurve Switch 3500yl-24G-PWR# configure
ProCurve Switch 3500yl-24G-PWR(config)# write memory
7. Configure Closet-A ProCurve 2626-24-PWR Switch
This section addresses configuring the Closet-A ProCurve 2626-24-PWR Switch. The ProCurve
2626-24-PWR Switch was used as an edge switch to supply PoE power, support VLANs and to
enforce QoS policies.
To configure the ProCurve 2626-24-PWR Switch, connect a PC or laptop to the serial port of the
2626-24-PWR. Run a terminal emulation program with the following configuration:
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow Control: None