Filter
Top Products
RoadRunners BRR-L & BRR-LA Programming guide Nov 2007
© Baracoda 2007 7/29
For example: to set the current time at 16th May 2007, 3.25 pm, the user will scan:
- “Set Timestamp” label,
- “0” label,
- “7” label,
- “0” label,
- “5” label,
- “1” label,
- “6” label,
- “1” label,
- “5” label,
- “2” label,
- “5” label,
- “0” label,
- “0” label,
- “end of config” label.
2.4/ Reading Mode
• In trigger mode, pressing the trigger will activate the beam.
• The Aiming trigger mode has been developped for users who need to scan barcodes very close each others
and they have to be sure to always read the corect one. Once in this mode, in order to read a barcode user
will have to press the trigger twice. Pressing it the first time will switch on the beam but will not switch on the
decoder (thus allowing user to aim at the correct barcode) while pressing the trigger the second time will
activate the decoder thus allowing the RoadRunners to actually decode the barcode.
• In autoscan mode the beam will be continuously on
• In Smart Autoscan, for a battery power consumption optimisation issue, the scanner will be continously
flashing.
Trigger (*)
Aiming Trigger Mode
Autoscan
Smart Autoscan