Filter
Top Products
MatrixPRO-II 3G/HD/SD-SDI Routers Rev. 1.1
MatrixPRO-II HD/3G SDI Series –User’s Guide - Rev. 1.1
23
6 Control Panel operation
6.1 Button description
A/V Toggle
The A/V Toggle button enables/disables audio and video on a specified address. The address
can either be read from the dip switches, or be fixed. The button toggles between three
states.
If the button is pressed for more than 1 second, it will go into a fourth state
where both audio and video are disabled.
In this state the button will be dimmed. If the button is pressed for more than 1 second
again, it will enable both audio and video if present.
Button Color
Video Enabled
Audio Enabled
Yellow Yes Yes
Green Yes No
Red No Yes
Dimmed No No
If neither audio nor video is present, it will be marked as disabled and the toggle state will
not be used.
Toggle status changes will be stored in flash and used when the panel is powered up later.
When a panel is powered on it will search for connected routers. If no routers are
found the A/V Toggle button will be disabled (no light in the button).
This can happen if the panel is powered up before any routers are connected or if
there is something wrong with the cabling.
To re-enable the A/V Toggle do the following:
1. Activate the Panel Enable button (Green light).
2. Push & Hold the A/V Toggle-button for 2 seconds.
The A/V Toggle-button should now be activated and the light turned on.
Panel Enable
If a Panel Enable button is present, the panel will start up not enabled. In this state the
button will be red and all the other buttons will be disabled. When pressing the button the
panel will be enabled and the color will change to green. A status request will also be sent to
get information on active levels.
If no Panel Enable button is present, the panel will start up enabled.