Filter
Top Products
1. Installation process
1. INSTALLATION PROCESS
About this chapter
This chapter describes how to replace the (univ ersal) lam p house from the FLM projector.
Adapted software for Universal Lamp House
The FLM projector software must be upgraded to version 1.7.17 or later prior to using the Universal Lamp House. The latest FLM
projector software can be downloaded from the Barco secured web site h
ttps://my.barco.com (browse to the product page of the
FLM projector). The FLM projector will n ot recognize the Universal Lamp House and will fail to start up the xenon b ulb lam p when
neglecting this software upgrade. Use the Projector Toolset, which is also available on the secured Barco web site, to upgrade the
projector software. See user guide of the Projector Toolset for detailed instructions on how to upgraded the projector software.
Overview
• Switching off
• Removal of the lamp cover
• Removal of the lamp house
• Installation of the lamp house
• Installation of the lamp cover
1.1 Switching off
How to switch off the projector?
1. Press first Standby.
2. Let cool down the projector until the fans decrease, at least 5 min.
3. Switch off the projector w ith the power switch.
1.2 Removal of the lamp cover
WARNING: This procedure may only be performed by qualified technical service personn el.
Necessary tools
7mmflat screw driver.
How to remove the lamp cover of the projector ?
1. Release the two captive screws at the top and bottom right side of the lamp cover, using a fla t screw driv e r.
R5976922 FLM LAMP HOUSE 18/11/2008
1