Filter
Top Products
1. Installation process
Image 1-3
4. Clasp the lamp h ouse by the handles and pull the lamp house out of the projector.
Image 1-4
While starting up the projector, the electronics detect if a lamp is installed. If no lamp is installed, it is not
possible to start up the projector.
1.4 Installation of the lamp house
WARNING: This procedure may only be performed by qualified technical service personn el.
CAUTION: Never attempt to disassemble the lamp from its housing or to dispose of it. Return it to Barco.
Due to its high internal pressure, the lamp ma y explode in either hot or cold states if improperly handled.
Necessary tools
7mmflat screw driver.
How to install the lamp house of the projector ?
1. Ensure the projec tor is switched off and the power cord at the projector side is unplugged.
2. Remove the lamp cover, if not removed yet. See "Removal of the lamp co ver", page 1 .
R5976922 FLM LAMP HOUSE 18/11/2008
3