Filter
Top Products
30
RF Options: Synchronize base
The wireless base and the remote have to be synchronized (same RF address and freq. band )
To synchronize the base follow next procedure:
1. Connect the 'COMM PORT' of the base to the 'COMM PORT' of the projector using a standard
cable (image 1)
2. Browse with when in the 'RF Options Menu'
3. Select 'Synchronize base' (Menu 1)
4. Press < ENTER>, the remote displays following message (menu 2)
5. Connect the RS232 port of the wireless base to the RS232 port of the remote using a standard
serial cable (image 1)
6. Press < ENTER>, the remote displays following message during a few seconds (menu 3)
7. Depending on whether the operation succeeded or not one of following messages may be
displayed (menu 4,5)
8. Exit the menu with <EXIT>
Menu Setup
+
-
NO COMMUNICATION
RF OPTIONS
SYNCHRONIZE BASE
NO UPDATE
CONNECT REMOTE TO BASE
AND PRESS <ENTER>
NO UPDATE
SYNCHRONIZING BASE
NO UPDATE
SYNCHRONIZATION FAILED
PRESS <ENTER> TO RETRY
Menu 1
Menu 4
Menu 3
Menu 2
NO UPDATE
BASE SYNCHRONISED
PRESS <EXIT> TO CONTINUE
Menu 5