Filter
Top Products
DS-RPC OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
__________________________________________________________________________________________
63
If the status menu fails to appear, ensure the
correct cables and adapters are being used
and they are connected properly. Also,
verify the serial
communication parameters
are correctly configured.
Controlling Receptacles
To set or change the status of receptacles,
enter one of the following commands: ON
n, OFF n, REBOOT n, where “n” is the
outlet number you want to command.
Entering an outlet number of “0” sends the
command to
all
outlets.
Example: To turn “On” Outlet 3, type
ON 3
from the
DS-RPC prompt (RPC >). The RPC
responds:
Turn On Outlet 3 (Y/N)?
Responding “Y” for yes turns “On” Outlet 3.
Observe the status of Outlet 3 has changed
to “On” in the status menu:
DS-RPC Power Control
(c) 1997 by BayTech
Rev. F0.04
Circuit Breaker : On
1) . . . OUTLET 1 : Off
2) . . . OUTLET 2 : Off
3) . . . OUTLET 3 : On
4) . . . OUTLET 4 : Off
RPC >
Likewise, typing
ON 0
at the RPC > prompt
and responding “Y” for yes, turns “On” all
outlets. Typing
OFF n
at the RPC > prompt
turns off corresponding outlet(s).