Filter
Top Products
ENGLISH
XENYX 1002B User Manual
5
Controls and Connectors 3.
Front Panel3.1
MIC
[1]
– Plug a microphone into this input using an XLR cable.
LINE IN
[2]
– Plug a line-level source into this jack using a ¼"
TS or TRS cable.
INS(ERT)
[3]
– Plug an external dynamic processor into this
jack using a TRS to dual TS cable. You may also use the
INSERT jack as a pre-EQ/pre-fader send by plugging in a
¼" TS cable part way to the rst click.
STEREO LINE IN
[4]
– Plug in a stereo source using two ¼"
TS cables, or a single line-level source using the left input
jack only.
GAIN LINE
[5]
– Adjusts STEREO LINE IN sensitivity, also
known as “gain setting.”
GAIN MIC
[6]
– Adjusts MIC input sensitivity, also known as
“gain setting.”
CLIP
[7]
– Lights when preamp begins to overload.
PAN/BAL
[8]
– Adjusts the left-to-right positioning of the
channel in the stereo eld.
HIGH
[9]
– Adjusts frequencies above 10 kHz by +- 15 dB.
MID
[10]
– Adjusts frequencies peaking at 700 Hz by +- 15 dB.
LOW
[11]
– Adjusts frequencies below 50 Hz by +- 15 dB.
MON
[12]
– Adjusts the amount of signal sent to the MON
SEND jack. This signal is sent pre-fader.
FX
[13]
– Adjusts the amount of signal sent to the FX SEND
jack. This signal is sent post-fader.
CHANNEL FADER
[14]
– Adjusts the channel volume in the
main mix.
2-TRACK OUTPUT
[15]
– Connect to the inputs of recording
device using RCA cables.
2-TRACK INPUT
[16]
– Connect to outputs of CD, tape or MP3
player using RCA or ¼" cables.
PHONES
[17]
– Connect a pair of headphones with a ¼" TRS
plug.