Filter
Top Products
42
Enhanced Wireless Router
SECTIONSTable of Contents 1 2 3 4 5 7 8 9 106
USING THE WEB-BASED ADVANCED USER INTERFACE
Using the Broadcast SSID Feature
Note: This advanced feature should be employed by advanced users
only� For security, you can choose not to broadcast your network’s
SSID� Doing so will keep your network name hidden from computers
that are scanning for the presence of wireless networks� To turn off
the broadcast of the SSID, remove the check mark from the box next
to “Broadcast SSID”, and then click “Apply Changes”� The change is
immediate� Each computer now needs to be set to connect to your
specific SSID; an SSID of “ANY” will no longer be accepted� Refer to
the documentation of your wireless network adapter for information on
making this change�
Protected Mode Switch
Protected mode ensures proper operation of 802�11g devices on
your Enhanced network when 802�11b devices are present or when
there is heavy 802�11b traffic in the operating environment� If you
are using a mix of Belkin Enhanced Wireless Cards and 802�11b or
802�11g cards on your network, protected mode should be used� If you
are in an environment where there is no other (or very little) 802�11b
wireless network traffic, best 802�11g performance may be achieved
with protected mode OFF� If you are operating in an environment with
HEAVY 802�11b traffic or interference, best 802�11g performance may be
achieved with protected mode ON� Wireless Enhanced performance is
not affected by this setting�
Using the Bandwidth Switch
This switch allows you to set the Router’s wireless bandwidth modes�
There are several modes available:
1) 20MHz only
Setting the Router to this mode allows only 20MHz operation� This
mode is compatible with draft 802�11n-, 802�11g-, and 802�11b-compliant
devices, but will limit draft 802�11n-compliant devices’ bandwidth by
half� Reducing bandwidth to 20MHz-only operation might solve some
wireless problems�
2) 20MHz/40MHz Auto
Setting the Router to this mode allows it to switch automatically
between 20MHz and 40MHz operation� This mode enables 40MHz
operation, to maximize speed for draft 802�11n-compliant devices when
conditions permit� When a legacy 802�11g access point is presented
and occupies an adjacent secondary channel, the Router automatically
reverts to 20MHz operation to maximize compatibility� We recommend
using this as the default mode�
802.11e/WMM QoS Switch
Allows you to turn ON or OFF wireless QoS�