Filter
Top Products
11
TROUBLESHOOTING
There is no image, or the image has no vertical hold.
1.
The monitor and the computer are not synchronized correctly.
Try changing the settings of both DIP switches 5 and 6, or just
DIP switch 7.
2. The monitor does not support the resolution selected.
Try changing to a different switch setting, and then restart
the computer.
There is no color in the image.
This is most likely caused by changing switch settings while the
computer boots up. Go into the “Control Panel/Monitors” in the
Macintosh Apple menu. Select the color depth you prefer, and
click “OK”.
The image is too small on the screen.
1.
Adjust the screen size by using the controls on your monitor.
2. If the monitor cannot expand the image to fit the entire screen
using its controls, the monitor simply cannot support that
resolution. Try switching to a lower resolution.
If your question was not answered here, please e-mail your
question to techsupp@belkin.com or call Belkin Technical Support
at 310-898-1100 ext. 2263.
Before calling, please ensure that you have all of your
equipment connected and powered ON, and that you are
at the computer.
10
Your Belkin VGA Adapter is capable of either “multimode” or
“fixed-mode” settings.
Multimode settings allow you to change resolutions anytime
through the Control Panel/Monitors in the Mac OS
®
, without having
to restart your computer. A MultiSync monitor may be required for
some settings, depending on which Mac OS and Mac computer you
are using.
Fixed-mode settings, unlike multimode, keep your monitor on one
resolution. In order to change resolutions once fixed-mode is in
effect, you must change the settings on your VGA Adapter, and
then restart your computer.
Finding Other Multimode Settings
To find other settings supported by your Mac, review Table 1.
Note: For example, the Mac LC II has an “X” in columns A and B.
Look in Table 2 for rows A and B. There, you pick your preferred
setting. Setting B is more desirable than A because it is a
multimode setting, and allows you more flexibility in choosing
resolution settings. Be sure your monitor supports the settings you
wish to use before proceeding.
Set your VGA Adapter’s rotary knob on 0 and all the DIP switches
OFF, except 8, as described on setting# B in Table 2.
Restart your computer. You will have the multimode selections in
your Mac Control Panel.
REFERENCE
P72551-A_F3H1381-manual.qxd 3/10/03 3:56 PM Page 10