Filter
Top Products
22
Firmware-Upgrade Guide
Step 7.
Click the “Browse” button and locate the firmware-upgrade file, which is indicated
with a file extension such as “*.uni”.
Select the upgrade file (for example: “UCF-30-11-07.uni”) and click “Choose” to load
the file. Then click “Upgrade” for upload.
Begin the File Upload
Note: Before clicking on the “Upgrade” button on the utility program, you should
make sure that you are focused on port 1 of the KVM Switch where you have the Mac
host connected. If not, switch to that port before clicking the “Upgrade” button.
Step 8.
After you click the “Upgrade” button, the file-transfer progress will begin in seconds
and can be monitored through the advancement of the progress bar. Wait until the
progress bar runs through its full length for the upgrade process to complete.
Note: Meanwhile, be careful not to power off the computer or disconnect the USB-
cable connection. Otherwise, the file download will be interrupted and the upgrade
process will be aborted. If that does happen, please refer to the “Firmware-Upgrade
Troubleshooting” section.