Filter
Top Products
2626
Local Installation
Getting Started:
1. Make sure that all servers and Switches are powered off and that each KVM
Switch has been assigned a unique BANK address.
2. Place the SMB KVM-over-IP Switch and all secondary KVM Switches in the
desired location.
3. Connect the console monitor, keyboard, and mouse to the console ports
of the SMB KVM-over-IP Switch. Refer to “Connecting the Console to the
Switch” on page 14.
Connecting the Primary and Secondary KVM Switches:
1. Using the Daisy-Chain Cable (F1D108-CBL-XX), connect one end to the
“Daisy-Chain” port on the SMB KVM-over-IP Switch.
2. Connect the other end of the Daisy-Chain Cable to the “Primary Input/
Secondary Output” port of the first secondary KVM Switch (BANK 01).
3. To add secondary units, connect one end of the Daisy-Chain Cable to the
“Secondary Input” on the first secondary KVM Switch and the other end
to the “Primary Input/Secondary Output” port of the next secondary KVM
Switch (for example, BANK 01).
4. Repeat step 3 for additional KVM Switches you wish to add to your
daisy-chain configuration.