Filter
Top Products
4
4. The program will begin installing at this point.
The first screen you will see is the following:
• Select “F1U109” because that is the
autoswitch that you have.
• Select which LPT port you installing the
AutoSwitch on. Normally, it is always
LPT1.
• Click continue when done.
5. The install program will then ask you for the
location of the install files. Because your floppy
drive is “A:”, just click OK.
6. When done, the program will display the following message:
Click OK, and installation is complete!
7. Next, you will see a box with the following
instructions. Click OK.
8. Reboot your computer. THIS IS A VERY
IMPORTANT STEP!!! YOU MUST REBOOT,
OTHERWISE, THE SOFTWARE WILL NOT
INITIALIZE, AND YOU CANNOT CONTINUE
PROPERLY. Do this by clicking on START, SHUT
DOWN, and RESTART.