Filter
Top Products
11
1
2
3
4
5
6
7
section
Installation
Step3 ConnectingComputerstotheSwitch(required)
3.1 Make sure all computers and the Switch are powered off.
3.2 Using the Belkin DVI/USB KVM Cable Kit (F1D9201-XX), connect the
male DVI connector to the monitor port on your computer. Then connect
the other end of the cable into an available port on the Switch. (Refer to
diagram below.)
3.3 Using the Cable Kit, connect the USB Type A connector to an available
USB port on your computer. Then connect the USB Type B connector to
the corresponding USB port on the Switch. (Refer to diagram below.)
3.4 Connect the two audio cables (audio and microphone) to your computer.
Then connect the other end to the corresponding audio and microphone
port on the Switch.
3.5 Repeat the steps above for each additional USB computer you wish
to connect.
Note: The Cable Kit must be connected directly to a free USB port on your
computer, with no USB hubs or other devices in between.