Filter
Top Products
12
Installation
Step4 PoweringUptheSystems(required)
4.1 Power on the attached monitor.
4.2 Attach the power adapter to the DC power jack labeled “5V, 3A” on the
back of the Switch. Only use the power adapter supplied with the Switch.
(Refer to diagram below.)
4.3 Power on your computers. All computers can be powered
on simultaneously.
Note:Your computers should recognize the Switch and automatically install the
HID USB driver if necessary.
When you power on your computers, the Switch emulates both a
mouse and keyboard on each port and allows your computers to
boot normally. The computer connected to port “1” will be displayed
on the monitor. Check to see that the keyboard, monitor, and mouse
are working normally. Proceed to do this with all occupied ports to
verify that all computers are connected and responding correctly.
If you encounter an error, check your cable connections for that
computer and reboot. If the problem persists, please refer to the
Troubleshooting section in this User Manual.