BenQ AWL-500 Network Card User Manual


 
BENQ Corporation
-11-
stations are within range of the same Access Point, but are not within range of each
other. Therefore, they are hidden nodes to each other. When a hidden station
starts data transmission with the Access Point, it might not notice that the other
station is already using the wireless media. When these two stations send data at
the same time, they might collide when arriving simultaneously at the Access Point.
The collision will most certainly result in a loss of messages for both stations. Thus,
the RTS Threshold mechanism will provide the solution to prevent data collisions.
When the RTS is activated, the station and its Access Point will use a Request to
Send/Clear to send protocol (RTS/CTS). The station will send an RTS to the
Access Point, informing that it is going to transmit the data. Upon receipt, the
Access Point will respond with a CTS message to all station within its range to notify
all other stations to defer transmission. It will also confirm to the requesting station
that the Access Point has reserved the channel for transmission.
Fragmentation Threshold: Fragmentation mechanism is used for improving the
efficiency when there is high traffic within the wireless network. If you transmit
large files in a wireless network, you can enable the Fragmentation Threshold and
specify the packet size. The mechanism will split the packet into the packet size you
set.
Rate Set: By default, the unit adaptively selects the highest possible rate for
transmission. In case of obstacles or interference, the system will step down. Select
the Basic Rates to be used among the following options: 1 - 2 (Mbps), 1 - 2 - 5.5 –
11 (Mbps). Select the TX Rate set among the following options, (1 – 2 - 5.5 - 11
Mbps) or (1 - 2 Mbps).
Preamble Type (Short/Long): Preamble is the first sub field of PPDU, which is
the appropriate frame format for transmission to PHY (Physical layer). There are
two options, Short Preamble and Long Preamble.
Information
Statistics
This item displays the Ethernet and wireless network traffic: