BenQ MP576 Projector User Manual


 
Introduction 13
Remote control effective range
Infra-Red (IR) remote control sensor is located on the
front of the projector. The remote control must be held at
an angle within 30 degrees perpendicular to the
projector's IR remote control sensor to function correctly.
The distance between the remote control and the sensor
should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote
control and the IR sensor on the projector that might
obstruct the infra-red beam.
Replacing the remote control battery
1. Pull out the battery holder.
Please follow the illustrated instructions. Push and hold the
locking arm while pulling out the battery holder.
2. Insert the new battery in the holder. Note the
positive polarity should face outward.
3. Push the holder into the remote control.
Avoid excessive heat and humidity.
There may be battery damage if the battery is incorrectly
replaced.
Replace only with the same or equivalent type
recommended by the battery manufacturer.
Dispose of the used battery according to the battery
manufacturer's instructions.
Never throw a battery into a fire. There may be danger of an explosion.
If the battery is dead or if you will not be using the remote control for a long time, remove
the battery to prevent damage to the remote control from possible battery leakage.
13. Timer On
Activates or displays an on-screen
timer based on your own timer
setting.
"Setting the presentation timer" on page
37
14. Timer Set up
Enters presentation timer setting
directly.
"Setting the presentation timer" on page
37
15. Page Up/Down
(This function is not available with the
MP5 series models.)
A
p
pr
o
x
.
1