Filter
Top Products
Introduction10
Manually corrects distorted images resulting from an angled projection.
7. Page Up and Down (Refer to "Remote paging operations" on page 26 for more
information.)
You can operate your display software program (on a connected PC) which responds to
page up/down commands (like Microsoft PowerPoint) by pressing
these buttons.
8. Auto (Refer to "Auto-adjusting the image" on page 23 for more information.)
Automatically determines the best picture settings for the displayed image.
9. Source (Refer to "Switching input signal" on page 25 for more information.)
Sequentially selects the input signal RGB, Component Video,
S-Video or Video.
10. Blank (Refer to "Hiding the image" on page 25 for more information.)
Used to hide the screen image. Press any key on the remote control to restore the
image.
11. Mode (Refer to "Application Mode" on page 29 for more information.)
Depending upon which input signal is selected, there are several picture setup options
available.
Remote control effective range
Infra-Red (IR) remote control sensors are located on the front and the back of the projector.
The remote control must be held at an angle within 30 degrees of the projector’s IR remote
control sensors to function correctly. The distance between the remote control and the
sensors should not exceed 6 meters (~ 20 feet).
Make sure that there are no obstacles between the remote control and the IR sensors on the
projector that might obstruct the infra-red beam.
Replacing the remote control battery
1. Pull out the battery holder.
2. Insert the new battery in the holder. Note
the positive polarity should face outward.
3. Push the holder into the remote control.
• Avoid excessive heat and humidity. There
may be battery damage if the battery is
incorrectly replaced.
• Replace only with the same or equivalent
type recommended by the battery
manufacturer.
• Dispose of the used battery according to the manufacturer’s instructions.
• Never throw a battery into a fire. There may be danger of an explosion.
• If the battery is dead or if you will not be using the remote control for a long time, remove
the battery to prevent damage to the remote control from possible battery leakage.
~ 6 M