Filter
Top Products
Operation 29
password in this manual, and you absolutely do not remember it, you can use the password
recall procedure. See "Entering the password recall procedure" on page 29 for details.
If you enter an incorrect password 5 times in succession, the projector will automatically
shut down in a short time.
Entering the password recall procedure
1. Press and hold AUTO on the projector or remote
control for 3 seconds. The projector will display a
coded number on the screen.
2. Write down the number and turn off your
projector.
3. Seek help from the local BenQ service center to
decode the number. You may be required to
provide proof of purchase documentation to
verify that you are an authorized user of the
projector.
Changing the password
1. Open the OSD menu and go to the SYSTEM SETUP: Advanced > Security Settings >
Change password menu.
2. Press Mode/Enter. The message 'INPUT CURRENT PASSWORD' displays.
3. Enter the old password.
• If the password is correct, another message 'INPUT NEW PASSWORD' displays.
• If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT CURRENT PASSWORD' displays for your retry.
You can press Menu/Exit to cancel the change or try another password.
4. Enter a new password.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected
password down here in this manual in advance or right after the password is entered so that it
is available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
5. Confirm the new password by re-entering the new password.
6. You have successfully assigned a new password to
the projector. Remember to enter the new
password next time the projector is started.
7. To leave the OSD menu, press Menu/Exit.
Disabling the password function
To disable password protection, go back to the SYSTEM SETUP: Advanced > Security
Settings > Power on lock menu after opening the OSD menu system. Select Off by pressing
/ . The message 'INPUT PASSWORD' displays. Enter the current password.
•If the password is correct, the OSD menu returns to the Security Settings page with
'Off' shown in the row of Power on lock. You will not have to enter the password
next time you turn on the projector.