Filter
Top Products
Maintenance
20
Benq Corporation
1. Press the POWER button to switch off the projector. Disconnect the power
cord from the outlet and the projector.
2. Loosen the screw and remove the lamp cover. If the lamp is hot, avoid burns by
waiting 45 minutes until the lamp has cooled.
3. Loosen the 3 screws. (It is strongly recommended you use a magnetic-headed
screwdriver.) Pull the handle to remove the lamp housing. If the screws are not
loosened completely, they could injure your fingers. Do not insert your hand into
the box after the lamp is removed. If you touch the optical parts inside, this could
cause color unevenness.
4. Replace the lamp with a new one. Insert it into the projector, and tighten the
screws firmly. Loose screws may cause a bad connection, which may result in
malfunction.
5. Re-install the lamp cover and tighten the screw. Do not turn on the power with
the lamp cover removed. Whenever the lamp is replaced, reset the total lamp
operation time. Do not reset if the lamp is not replaced as this could cause
breakage.