Filter
Top Products
25
Using the projector
Selecting an input source
The projector can be connected to multiple equipment at the same time.
When the projector is first turned on, it will attempt to reconnect with
the input source which was in use when the projector was last shut
down.
To select the video source:
• Using the remote control or projector
1. Press SOURCE on the projector or remote control. A source
selection bar displays.
2. Press / until your desired signal is selected and press MODE/
ENTER.
• Using the OSD menu
1. Press MENU/EXIT and then press / until the System Setup : Basic menu is highlighted.
2. Press to highlight Input Source and press MODE/ENTER. The source selection bar displays.
3. Press / repeatedly until your desired signal is selected and press MODE/ENTER.
Once detected, the selected source information will display on the screen for seconds. If there are
multiple pieces of equipment connected to the projector, you can go back to the source selection bar
again to search for other signals.
You can also rename the source:
1. Press MENU/EXIT and then press / until the System Setup : Basic menu is highlighted.
2. Press to highlight Source Rename and press MODE/ENTER. The Source Rename page
displays.
3. Press / / / until your desired character is selected and press MODE/ENTER.
• If you want the projector to automatically search for the signals, select On in the System Setup :
Basic > Auto Source Search menu.
Fine-tuning the image size and clarity
NOTE: When
automatically
searching for a
valid input source,
the projector
cycles through
the available
signals following
the sequence
from top to
bottom as the
source selection
bar shows.
HDMI 1
HDMI 2
Video
S-Video
Component
PC
1. Adjust the projected picture to the size
that you need using the zoom ring.
2. Sharpen the picture by rotating the focus
ring.