Filter
Top Products
27
Using the projector
Utilizing the password function
For security purposes and to help prevent unauthorized use, the projector includes an option for setting
up password security. The password can be set through the On-Screen Display (OSD) menu. Once the
password is set and this function is selected, the projector is password-protected. Users who do not
know the correct password can not use the projector.
You will be inconvenienced if you activate the password functionality and subsequently forget the password.
Print out this manual (if necessary) and write the password you used in this manual, and keep the manual in
a safe place for later recall.
Setting a password
Once a password has been set and activated, the projector cannot be used unless the correct password is
entered every time the projector is started.
1. Press MENU/EXIT on the projector or remote control and then
press / until the System Setup : Advanced menu is
highlighted.
2. Press to highlight Password and press MODE/ENTER. The
Password page displays.
3. Highlight Change Password and press MODE/ENTER. The
Input Password page displays.
4. As the picture indicates, the four arrow keys ( , , , )
respectively represent 4 digits (1, 2, 3, 4). According to the password you desire to set, press the
arrow keys on the remote control or projector to enter six digits for the password.
Confirm the new password by re-entering the new password.
Once the password is set, the OSD menu returns to the Password page.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected password
down here in this manual in advance or right after the password is entered so that it is available to you
should you ever forget it.
Password: __ __ __ __ __ __
5. Highlight Power On Lock and then press / to select On.
6. Confirm the current password.
7. To leave the OSD menu, press MENU/EXIT.
If you forget the password
If the password function is activated, you will be asked to enter the six-
digit password every time you turn on the projector. If you enter the
wrong password, the password error message as pictured to the right
displays lasting for three seconds, and the Input Password page
follows. You can retry by entering another six-digit password, or if you
did not record the password in this manual, and you absolutely do not
remember it, you can use the password recall procedure. See "Entering
the password recall procedure" on page 28 for details.
If you enter an incorrect password 5 times in succession, the projector
will automatically shut down in a short time.
Input New Password
Back
Password Error
Please try again.