Filter
Top Products
24
Using the projector
English
Entering the password recall procedure
1. Make sure the Input Password page displays on screen. Press and hold
PRESET MODE on the projector or remote control for 3 seconds. The
projector will display a coded number on the screen.
2. Write down the number and turn off your projector.
3. Seek help from the local BenQ service center to decode the number.
You may be required to provide proof of purchase documentation to
verify that you are an authorized user of the projector.
Changing the password
1. Press MENU on the projector or remote control and then press / until the Advanced Setup menu is
highlighted.
2. Press / to highlight Password and press ENTER. The Password page displays.
3. Highlight Change Password and press ENTER. The Input Current Password page displays.
4. Enter the old password.
• If the password is correct, the message "Input New Password" displays.
• If the password is incorrect, the password error message displays lasting for three seconds, and the
message "Input Current Password" displays for your retry. You can either press MENU to cancel
the change or try another password.
5. Enter a new password.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected password
down here in this manual in advance or right after the password is entered so that it is available to you
should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
6. Confirm the new password by re-entering the new password.
7. You have successfully assigned a new password to the projector. Remember to enter the new password
next time the projector is started.
8. To leave the OSD menu, press MENU.
Disabling the password function
To disable password protection, go back to the Advanced Setup >
Password > Password menu. Highlight Password and select Off by
pressing / . The message "Input Password" displays. Enter the current
password.
• If the password is correct, the OSD menu returns to the Password
page with "Off" shown in the row of Password. You will not have
to enter the password next time when turning on the projector.
• If the password is incorrect, the password error message displays
lasting for three seconds, and the message "Input Password"
displays for your retry. You can either press MENU to cancel the
change or try another password.
Note that though the password function is disabled, you need to keep the old password in hand should you
ever need to re-activate the password function by entering the old password.
Please write down the recall code, and
contact your nearest BenQ Customer
Center.
Recall code:
0 2 1 2
Recall Password
EXIT Back
Password
Password
Change Password
Off
EXIT Back