Beyerdynamic MCS 20 Power Supply User Manual


 
MCS 20 – MCS 223 Microphone Unit
42
Step 4 – How to change the selected value
Press one of the “Vol” buttons , until the requested value is displayed .
Step 5 – How to return to the function display
Press the [+] or [-] limit button to change from the displayed selected value (flashing full stop on the right) to
the function display (flashing full stop on the left).
Adjust further values of any functions by starting with step 3. When all settings are done, they can be filed under a
setup number of 1 - 7 by using the function 00.
When you leave the programming mode with step 6, all new settings remain automatically stored (also without
saving in a setup) to the next change or when loaded a stored setup - even without any operating voltage.
Step 6 – How to leave the programming mode
If there is no entry after one minute, the programming mode is automatically left. Furthermore, you can leave the
mode as described in the following:
Press the “Clear” button .
OR
Press the “Voice” and “Requ” buttons simultaneously (press the “Voice” button first) to leave the
programming mode.
How to access standard values
Press the buttons “Voice” + “Free” + “Requ” (all three buttons simultaneously - press the “Voice”
button first - and release). Then all current functions 1 - 15 are loaded with the standard values according to
the function table.
This action does not change the values for the timer functions 16 - 21. The last settings remain stored.
How to save the configuration
The current “Limit”, “Volume” and “Mode” settings remain automatically stored with the current values of the
functions 1 - 21 (refer to function table) until new values are set or stored setups are loaded - also without
operating voltage.
With the function 00 all settings are stored under a setup number (1 - 7) to be loaded later. If the “Limit”,
“Volume” and “Mode” settings are not yet adjusted, you should do so now.
Step 1 – How to activate the programming mode and adjust settings
Activate the programming mode and set the requested values. This can be done by loading a setup and
modifying the settings.
Step 2 – How to select the function 00 (access setup menu)
Press the [-] “Limit” button until the function number 00 is displayed. The left full stop is flashing.
Step 3 – How to select a setup number
Press one of the “Vol” buttons until the desired setup number (1 - 7) is displayed . The right full stop is
flashing.
Step 4 – How to save a setup
Press the microphone button to save the setup under the selected setup number. Please make sure that the right
full stop is flashing in the display when saving. All displays are briefly turned off to confirm that the saving has
been successful.
Step 5 – How to leave the programming mode
If there was no entry after one minute, the programming mode is automatically left. Furthermore, you can leave
the mode as described below:
Press the “Clear” button to leave the programming mode.
OR
Press the “Voice” and “Requ” buttons simultaneously (press the “Voice” button first) to leave the
programming mode.
Note: You should record the settings saved in the setups (e.g. in a copy of the table of programmable functions).