Filter
Top Products
6
Device Overview
The Description of each labeled part is described in the table below.
AC Outlet / AC Pass-
thru (only available in
BiPAC 2074)
Filtered AC Pass-through available for electrical devices with Input:
100~240V AC, 50~60Hz, 6Amp (Maximum).
1.0 DET LED Blinking when detecting other HomePlug 1.0 devices that have the
transmission rate of 14 or 85 Mbps.
Note: Due to the incompatibility of HomePlug AV 200 with
HomePlug 1.0 devices, the presence of the HomePlug 1.0 devices
within the powerline network will thus reduce the performance of
your powerline network.
Power LED Lit when the device is power on.
Blinking when the device enters power saving mode.
Lit off when power is off.
PLC (Powerline Link/
Act) LED
Lit when the power line sync is established.
Blinking when networking is active.
ETH (Ethernet Link/
Act) LED
Lit when connected to an Ethernet device.
Blinking when data is transmitted or received via Ethernet port.
Sync Button Used to establish a LAN network with other Ethernet devices.
Reset Button Press this button to for more than 2 seconds to reset device to factory
default settings.
Ethernet Port Connect the HomePlug AV device with an Ethernet device (e.g.
computer, router, hub/switch , IP pone, IPTV set-top-box, gaming
consoles…), using the RJ-45 Ethernet cable included.
Power Plug / AC Power
Cord
Plug into an AC outlet for power supply and to build a powerline
network with other HomePlug AV devices.
BiPAC 2073 BiPAC 2074
1.0 DET LED
Power LED
PLC LED
ETH LED
Sync Button
Reset Button
AC Power
Outlet / /
AC Pass-
thru (only
available in
BiPAC 2074)
Ethernet Port
Power Plug