Filter
Top Products
myGuard 7500GL 802.11g Security ADSL Router
Chapter 4: Configuration
TCP or UDP, however you can specify other protocols using the drop-down Protocol menu.
Setting the protocol to “all” will cause all incoming connection attempts using all protocols on all
port numbers to be forwarded to the specified IP address.
DMZ: The DMZ Host is a local computer exposed to the Internet. When setting a particular
internal IP address as the DMZ Host, all incoming packets will be checked by the Firewall and
NAT algorithms, then passed to the DMZ host when a packet received does not use a port
number used by any other Virtual Server entries.
Using port forwarding does have security implications, as outside users wil
l
be able to connect to PCs on your network. For this reason you are
advised to use specific Virtual Server entries just for the ports you
r
application requires instead of simply using DMZ or create a Virtual Serve
r
entry for “All” protocols, as doing so will result in all connection attempts to
your public IP address will access the PC specified.
If you have disabled the NAT option in the WAN-ISP section, the Virtual
Server function will hence be invalid.
Attention
Attention
If the DHCP server option is enabled, you have to be very careful in
assigning the IP addresses of the virtual servers in order to avoid conflicts.
The easiest way of configuring Virtual Servers is to manually assign static
IP address to each virtual server PC, with an address that does not fall into
the range of IP addresses that are to be issued by the DHCP server. You
can configure the virtual server IP address manually, but it must still be in
the same subnet as the router.
108