Filter
Top Products
Hardware Options
Modem 3600 E-3
Sn? page 10
-3
-- Read value in register n (decimal)
Sn?^ -- Read value in register n
(hexadecimal)
Sn=v -- Set v (value) in register n (decimal)
Sn=v^ page 10
-3
-- Set v (value) in register n
(hexadecimal)
Sn.#=v page 10
-4
-- Set single bit value in register n,#= bit
position 0-7, v = bit value 1 or 0
Vpage5-
6
S14 Response codes
V1 S14 Response messages
Wpage5-
6
S82 Negotiation display disabled
W1 S82 Negotiation display enabled
W2 S82 Displays DCE link rate
X S22 CONNECT (code 1), for all speeds, no
dial tone or busy signal detection
X1 S22 Appropriate connect codes for rate, no
dial tone detection
X2 S22 Wait for dial tone (appropriate
connect codes)
X3 S22 Detect busy signal (appropriate
connect codes)
X4 S22 Wait for dial tone, detect busy signal
(appropriate connect codes)
Ypage5-
25
S21 Long space disconnect disabled
Y1 S21 Long space disconnect enabled
Zpage5-
39
-- Reset to user option set #1
†
Z1 -- Reset to user option set #2
†
&C page 5-
19
S21 DCD always on
&C1 S21 DCD on while carrier is present
&C2 S21 DCD off 5 seconds after disconnect
&C3 S21 DCD follows remote RTS
Command Page S-Reg Description
†
cannot be executed from remote configuration mode