Filter
Top Products
AT Commands
5-40 Modem 3600
View Configuration Profiles/Received Signal Options
&V
This command lets the user view the current configuration profile in the
form of S-register values. &V1 displays the received signal options.
Storing a Telephone Command Line &Zx=n, *CNx,n,
*ND
Nine stored phone number locations of up to 31 characters each are
available in nonvolatile memory. Normally, one phone number per
location is accommodated. However, a phone number longer than 31
characters can overflow into the next location. Any spaces remaining in
the overflowed location cannot be used for another number. The stored
phone number is retained until replaced by another number. Modem
power can be turned off without affecting stored information.
To store a telephone command line in a location, enter the &Zx=n
command where x = the location and n = the number:
AT &Z 8 = 554-1212
In this example the command sequence to dial the indicated number is
stored at location 8 for later dialing.
Note
Neither the AT prefix nor the D command should follow the
&Zx=n.
• &Zx=n - Stores telephone number n, including dial modifiers, at
location x (0-9, up to 31 digits).
• *CNx,n - Stores telephone number n, including dial modifiers, at
location x (0-9, up to 31 digits).
• *CNx,- Clears telephone number location x
• *ND - Displays the stored numbers (1-9).
Command Operation
&V Displays configuration profiles
&V1 Displays received signal options
&V2 Displays active profile