Black Box AC504A-WP Network Hardware User Manual


 
Model AC504A-WP
8
2.3 Configuration for Composite Video and Stereo Audio
The AC504A-WP can be used to transmit Composite Video and Stereo
Audio instead of VGA or YPbPr to the receiver. However since the
Video signals are terminated differently than audio, you need to cut or
remove two jumpers on the rear of the unit.
For normal operation (VGA or YPbPr), J1 and J2 on the rear of the
unit, are installed. For transmitting composite video and audio, you
need to remove or cut these jumpers.
An HD15 to 3 RCA cable will be required. The composite video is sent
on the green (pin 2), and the light and left audio channels are sent on
the Red (pin 1), and Blue (pin 3). Note that some cables may have
Yellow (video), Red (right audio), and White (left audio) RCA
connectors instead of RGB connectors.
NOTES
If the length of Cat5 Cable is longer than 300 feet you
may need to attach a power supply to the receiver unit.
Generally if the remote display device is referenced to ground
(i.e. the VGA connector ground or case, is connected to power
line ground) you should not need an additional power supply to
the specified maximum length of 500 feet
Do not connect this unit to any LAN device such as
network cards or hubs as this may damage the AC155A and/or
the LAN device. Use EIA/TIA 568B standard straight-through
patch wiring. Do not use crossover cables.