Filter
Top Products
724-746-5500 | blackbox.com
Page 12
G.SHDSL Two-Wire Ethernet Network Extender
4. Console Configuration
The LR0201A-KIT has an RS-232C console port so users can monitor the OA&M status through a VT100 terminal. This section
covers the operating procedures and settings for all screen selections.
Connect the RS-232 cable to the COM port of the computer as shown in Figure 4-1. Set the personal computer to VT100 or
VT102 type through HyperTerminal. Press the <ESCAPE> key and the main menu will be shown on the screen of the terminal.
The terminal operations can then start.
If you press tthe <ESCAPE> key and the terminal’s screen does not display, the COM port setting might be incorrect. Choose the
right COM port (COM1 or COM2) on the computer, and press the <ESCAPE> key again to make sure that the main menu
appears on the terminal screen.
NOTE: Set the COM port to 9600 bps, no parity, 8 data bits, 1 stop bit, no flow control.
Figure 4-1. Connecting the console port to an RS-232 terminal.
RS-232 Cable
VT100/102 Terminal
PC COM Port
Baud rate: 9600
Parity: N
Data bits: 8
Stop bits: 1
Flow control: none