Filter
Top Products
Black Box®LB1350A/LB1351A
20
Management card configuration
---------------------------------------------------------------------
NETWORK PARAMETERS:
-------------------
IP address on LAN is 192.168.1.99
CONSOLE PARAMETERS:
-------------------
console channel will use a baud rate of 9600
BOARD PARAMETERS:
-----------------
Processor : MPC850, Running at 50Mhz
Board Info : Management Board
Board memory : FLASH : 4Mbytes
SDRAM : 4Mbytes
Board's Ethernet hardware address : 0:A0:D2:2F:80:82
---------------------------------------------------------------------
To change any of this, press any key within 5 seconds
Figure 2-1 – management parameters setup screen
When configuration is complete, the startup screen will appear with the new
parameters. If you still want to change any other parameters, type ‘M’ to modify.
Otherwise type ‘C’ to continue. Configuration parameters will now be saved and the
system will initialize (figure 2-3).
(M)odify any of this or (C)ontinue? [M] m
For each of the following questions, you can press <Return> to select the value shown in braces, or
you can enter a new value.
NETWORK PARAMETERS:
-------------------
Do you want a LAN interface? [Y]
This board's LAN IP address(0.0.0.0 = RARP)? [192.168.1.99]
Use a subnet mask for the LAN interface? [N] y
Subnet mask for LAN (0 for none)? [0.0.0.0]
Should there be a default gateway for packet routing? [N] y
What is its IP address? [0.0.0.0]
CONSOLE PARAMETERS:
-------------------
Baud rate for serial channels [9600]
ETHERNET PARAMETERS:
--------------------
Do you want to change the board's Ethernet address? [N] y
Byte 0 must be 00
What should byte 1 be? [A0]
What should byte 2 be? [D2]
What should byte 3 be? [2F]
What should byte 4 be? [80]
What should byte 5 be? [82]
SNMP PARAMETERS:
----------------
Get community [public]
Set community [private]
Trap destination [192.168.1.15]
Trap community [trap]
System name [FibroLAN]
System location [Israel]
System Contact [Shamir]
How long (in seconds) should CPU delay before starting up? [5]
Figure 2-2 – management parameters configuration