Filter
Top Products
in rackmount models. To modify the default SNMP settings, the Administrator must
make the edits at the command line as described in Chapter 15—Advanced
Configuration.
TFTP This service will set up the default tftp server on the USB flash card (and is relevant
to LES1508A, LES1408A, LES1416A, LES1432A, LES1448A, LES1308A, LES1316A,
LES1332A, LES1348A, LES1208A-R2, LES1216A-R2, LES1232A and LES1248A-R2
console servers only). This server can be used to store config files, and maintain
access and transaction logs, etc.
Ping The
Respond to ICMP echos (i.e. ping) allows the console server to respond to
incoming ICMP echo requests. Ping is enabled by default. For security reasons, you
should disable this service after initial configuration.
Nagios Access to the Nagios NRPE monitoring daemons (refer Chapter 8)
NUT Access to the NUT UPS monitoring daemon (refer Chapter 10)
SNMP This will enable netsnmp in the console server, which will keep a remote log of all
posted information. SNMP is disabled by default. To modify the default SNMP
settings, the Administrator must make the edits at the command line as described in
Chapter 15 – Advanced Configuration
NTP Refer Chapter 11
Click Apply. As you apply your services selections, the screen will be updated with a
confirmation message:
Message Changes to configuration succeeded.
3.4.2 Service Settings
The Administrator can access the console server, and connected serial ports and managed devices, using
a range of access protocols/services. However for each such access the particular service must first be
configured and enabled to run on the console server.
To enable and configure a service:
Select the Service Settings tab on the System: Services page
_____________________________________________________________________
724-746-5500 | blackbox.com Page 35