Filter
Top Products
724-746-5500 | blackbox.com
Page 20
Chapter 4: Installation
Table 4-1. LGC200A LC to LGC201A or LGC202A SC connection.
Part Number LGC200A LGC201A LGC202A
Transmision
Media
SFP module
850-nm
multimode
1310-nm
single-mode
4.2 Installation Procedure
Use a fiber cable to connect two converters and extend a copper link or to connect
a 1000BASE-FX segment to a 1000BASE-X segment on your network.
1. Connect a converter to a 1000BASE-TX device (hub or switch).
• Make sure that the CAT5 twisted pair cable between the 1000BASE-TX device
and the converter is less than 328 feet (100) meters long.
• Connect one end of the CAT5 twisted pair cable to the RJ-45 jack on the convert-
er and the other end of the cable to the RJ-45 jack on the 1000BASE-TX device.
2. Connect two converters or a converter and a 1000BASE-FX device.
• Use an SC fiber cable to connect the two converters’ SC connector or the SC
connector of a converter and a 1000BASE-FX device.
3. Turn on the power.
4.3 Install the Media Converter into the LHC200A-RACK
1. Take out the two screws located on the top of the chassis and use them to install
the retainer as shown in Figure 4-5.