Filter
Top Products
ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER USER’S MANUAL
28
4.2.1 PC/WORKSTATION USING TELNET UTILITY
Figure 4-3. PC/Workstation Using Telnet Utility.
NOTE
This configuration requires the TCP/IP protocol on your LAN.
Before configuring the Router with a PC or workstation using a third-party vendor’s telnet utility, you
must use the setaddr utility to set an IP address on the Router’s boot diskette.
setaddr requires a PC/workstation that can read and write 3.5-inch, 1.44-MB DOS diskettes; telnet does
not require this capability.
When using telnet to install Router software, the computer using telnet must be a node on the same
Ethernet LAN as the Router. You cannot use telnet to configure a Router until an IP address has been
assigned, using setaddr.
POWER
SERIAL
CONSOLE
10 BaseT
AUI
Modem 0
I
O
Ethernet Hub
Host
IP
10BASE-T,
AUI
10BASE-T
AUI