Filter
Top Products
ASYNC ROUTER AR-P, AR-5, AND SYNC ROUTER USER’S MANUAL
87
C.2.2 FOR IPX (NETWARE) NETWORKS ONLY
• filter—display or change IPX filters
• if config—display or change IPX network parameters
• ipx—display or change IPX protocol parameters
• netstat—display IPX network statistics
• ping—send an ICMP packet to remote host
• ripfilter—display or change RIP protocol filters
• route—display and change IPX routing tables
• sap—display and change SAP routing tables
• sapfilter—display or change SAP protocol filters
• spoof—enable or disable protocol spoofing
• tcp/ip—change to TCP/IP mode
C.2.3 F
OR TCP/IP NETWORKS ONLY
• arp—display or change ARP protocol parameters
• domain—configure for Internet domain name service (DNS)
• filter—display or change TCP/IP filters
• icmp—display ICMP protocol status
• ifconfig—display or change TCP/IP network parameters
• ip—display or change TCP/IP protocol parameters
• ipx—change to IPX mode
• netstat—display TCP/IP network statistics
• ping—send an ICMP packet to remote host
• rip—display or change RIP protocol parameters
• route—display or change IP routing table
• snmp—display or change SNMP protocol parameters
• syslog—display or configure system log
• tcp—display or configure TCP protocol parameters
• traceroute—trace the route to a host
• udp—display UDP protocol status
For detailed information about the use of these commands, refer to Chapters 2, 3, and 4 in the Reference
Manual, which begins on page 137.