Filter
Top Products
22
2.048Mb
p
s Wireless Modem
SALES: 0118 965 5100
4. From the Add/Remove Echo Cancellation on voice channels menu, type 2 to select the
Clear (Remove) Channels menu.
5. View the current list of channel with echo cancellation. If channels in which echo
cancellation should not be used are included, enter the numbers of the channels that should be
removed from the list. Enter numbers between 1 to 31 separated by a comma. Use two dots to
indicate a range. e.g. 2,5..7 means remove echo cancellation from channels 2, 5, 6 and 7.
6. Activate the new settings by selecting 4 from the Main Menu (System Reset) to reset the
unit after configuration. The system must be reset for the modified parameters to take effect.
7. Verify link functionality using the LED indicators (See page 15, for LEDs description).
8. Further configuration may be done using the setup and configuration functions, as
described in Chapter 3.
Note: A unit running software version 1.7 is not compatible and cannot be connected in a
link to a unit running software version 1.6 and earlier.
Antennas, Cables and Accessories
There is a variety of standard antennas, cable types, and RF accessories for different gain
levels available.
Antennas
Basic Antenna (Uni-8.5)
The basic antenna has a gain of 8.5 dBi. Low alignment accuracy is required because of the
relatively large beam width (75 degrees horizontal, 50 degrees vertical ). It is intended for
indoor or outdoor installation in locations with relatively short distances between sites. UNI-
8.5 dimensions are: 101 x 95 x 32 mm. (4 x 3.75 x 1.25 in.).