Blomberg TKF 7230 Printer User Manual


  Open as PDF
of 44
 
15 - EN
Progress of program
Progressofarunningprogramisshown
through the program follow-up indicator.
At the beginning of every program step,
the relevant indicator lamp will light up and
light of the completed step will turn off.
"Drying":
- Drying level will be illuminated during
the whole drying process until the drying
degree reaches "iron dry".
"Iron Dry":
- Starts to illuminate when the drying
degree reaches "iron dry" step and remains
illuminated until the next step.
" Cupboard Dry":
- Starts to illuminate when the drying degree
reaches " Cupboard dry" step and remains
illuminated until the next step.
“Cooling”:
- It lights up during the 4-minute cooling
phase at the end of drying.
“Final / Anti-creasing”:
- Illuminates when the program comes
to an end and anti-creasing function is
activated.
Important:
If more than one LED light up or flash
concurrently, it means there is malfunctioning
or a failure (please see, Solution
suggestions for problems).
Changing the program after the
program has started
Youcanusethisfeatureafteryourmachine
has started to dry your clothes under higher
or lower temperatures.
For example;
Pressandholdthe“Start/Pause/Cancel”
buttonforabout4secondsto“Cancel”
theprograminordertoselect“ExtraDry”
programinsteadof“IronReady”program.
Selectthe“ExtraDry”programbyrotatingthe
program knob.
Press"Start/Pause/Cancel"buttontostart
the program.
C The program which is selected first will
go on even if the program selection
button is moved and another program
mode is selected while the machine is
operating.Youmustcanceltheongoing
program in order to change the drying
program. (See, Ending the program
through canceling)
Adding/removing laundry in standby
mode
In order to add or take out laundry after the
start-up of the program;
1. Pressthe“Start/Pause/Cancel”button
toswitchthemachineto“Pause”mode.
Drying process will stop.
2. OpenthedooratPausepositionand
close it again after adding or taking out
laundry.
3. Press"Start/Pause/Cancel"buttonto
start the program.
C Any laundry added after the drying
process was started may cause the
already dried clothes in the machine
intermingle with wet clothes and the
result will be wet laundry after the drying
process is over.
C Laundry may be added or taken out
as much as desired during a drying
process, but as this process will interrupt
drying continuously, it will extend
the program duration and increase
energy consumption. Therefore, it is
recommended to add laundry before the
drying program is started.
Child-proof lock
There is a childproof lock to prevent any
program interruption due to the pressing
of keys while the program is on. In order
to activate the childproof lock, press on
the“AudioWarning”and“timedelay”
buttons simultaneously for 2 seconds. The
“Childprooflock”willbeactivatedanda
warning led will light up.
 previous next