Filter
Top Products
4.0 Installation
The Adjustable MC Ghost ticket printer is designed to be mounted on a desktop or on
a shelf. Prior to the site preparation and installation, the printer should be posered up
and run in the self test mode. Lay the printer flat on a counter as shown in figure 3.
Verify that line voltage is the same as the line voltage specified on the serial tag.
Attach the AC cord and interface connector into the proper connectors as shown in
figure 4. Turn power on. The LCD will display PAPER OUT. If required adjust the
variable width paper guide (see Configuration in section 5.0). Begin loading tickets
through the entrance slot with a smooth motion until the printer automatically positions
the ticket.
After the ticket is automatically positioned (the READY LED will be illuminated), press
the TEST button located on the control panel to print a test ticket. Verify that the
printer properly works with your system by issuing a ticket through your computer
system.
You may now install the printer in the desired location ensuring adequate room is
provided for cables and ventilation.
FEED DIRECTION
Thermal Side of
Stock
5
Figure 6 - Ticket Loading
BOARDING
PASS
BAG TAG