Filter
Top Products
24 en | Configuration Using HyperTerminal ATM/POS Bridge
F.01U.171.816 | 1.0 | 2010.09 Installation Manual Bosch Security Systems, Inc.
6 Configuration Using HyperTerminal
You can configure the ATM/POS Bridge via a PC HyperTerminal
session. The PC is connected to the COM 3 (console) port on
the bridge via a serial connection.
For instructions to update the ATM/POS Bridge firmware, refer
to Section A Updating Bridge Firmware, page 36.
6.1 Connecting the Bridge
1. Ensure that the bridge is connected to the power supply.
2. Connect the supplied console cable to COM Port 3
(console) on the bridge.
3. Connect the other end of the console cable to a serial port
on the PC.
6.2 Initiating a HyperTerminal Session
1. Launch the HyperTerminal application on the PC. This
application is usually found on the Windows Start menu
under the Programs -> Accessories -> Communications
folder.
2. Type a name for the new HyperTerminal session and select
an icon for the session, then click OK.
3. Select the appropriate COM port number on the PC that is
connected to the bridge, then click OK.