Filter
Top Products
12 Getting Started
1.10 Power-up Configuration and Self-Test
With the Printer off, load the media to be used (at least 4 inches wide) and
ribbon (if equipped and/or desired). Press and hold the Feed Button and
turn the Printer on, continue holding the Feed Button until the media
begins to move then release the Feed Button. The Printer will
automatically detect if a ribbon has been installed, and the Printer will
then print the two test labels.
Note: After performing a Power-Up and Self-Test, the Printer will be in
'Character Dump Mode'. Turn the Printer off
momentarily, then back on to restore normal operation.
To reset the Printer to 'Factory Defaults':
With the Printer off, press and hold the Feed Button while turning the
Printer ON. Continue to hold the Feed Button for 60 seconds and then
release. The Printer will now be set to the 'Factory Defaults'.
The first label printed will be the Configuration Label, which lists the
Printer's configuration and status.
FRI SEPTEMBER 026, 1995 19:29 244
ROM CHECKSUMS
U09
U10
SYSTEM RAM CHECKS____ GOOD SYSTEM RAM SIZE__ 512
KBYTES
CONFIGURATION
9600,8,N
DIRECT
INPUT VALUES
PAPER: 228 EDGE: 179 REFL: 0 TEMP: 89
POT : 212 TOFA: 133 RIBN: 0
COUNTER INFORMATION
ABSOLUTE VALUES 9-18-1994 RESETABLE VALUES 9-18-
1994
LENGTH____ 773 INCHES LENGTH____ 576
INCHES
TIME______ 10 HOURS TIME______ 4
HOURS
MEMORY CONFIGURATION