Filter
Top Products
21
CAUTION! Side Tilt Panels must remain open and pinned, Access Doors must
remain closed during Power Winding operations. Be sure side panels are
securely pinned in the open position. Failure to do this may cause damage to
machine and cable.
A. Turn on electronic controller’s switch on control panel.
B. Input cable diameter using the Select and (+) and (-) keys on the Hand-Held
Wired Remote Controller. The reading is in millimeters only.
NOTE: A Vernier Caliper (supplied) or a cable diameter gauge (not included) can be
used to measure outside cable diameter (OD) on site.
C. Start the engine by depressing the electric start button on the Electronic
Machine Controller panel.
D. Turn the throttle up on the engine.
E. Be sure the Load Dial on the Hand-Held Wired Remote Controller is set at
zero (counterclockwise). The loading process will not start if the Load Dial
is not set at zero.
F. Press the Start button on the
Hand-Held Wired Remote. The
LED will come on. If the LED is
flashing, the Load Dial was not set
to zero. Turn the Load Dial com-
pletely to zero (counterclockwise)
and press the Start button again.
G. Begin winding by gradually turning
the Load Dial on the Hand-Held
Wired Remote Controller
clockwise (Figure 28). Winding
speed will continue to increase
as the dial is turned clockwise
and will decrease by turning
counterclockwise.
Important! Always start the winding operation slowly, and gradually increase
speed to attain maximum operation efficiency and cable safety.
Important! The operation may be shut down immediately by any one of the
following actions:
• Stop button is depressed on the Hand-Held Wired Remote Controller.
• Access Door is opened.
• Emergency Stop button is depressed at the Electronic Machine
Controller panel. (Requires restart of the electronic controllers.)
H. The drum will automatically reverse directions at the ends of the drum as
the power winding continues.
Figure 28. Wind Load Dial
Clockwise