Filter
Top Products
23
F. Use the Drag dial to adjust the amount of drag placed on the arms during
unloading. It is essential to keep cable from developing slack. Start with
very little drag and increase to desired level and monitor throughout entire
unloading process.
G.Remove last 4-5 wraps manually. Activate the Arm Disengage switch on the
Electronic Machine Controller panel and rotate arms by hand.
H. Remove cable from quad and single keeper rollers using the procedure
described in Section 7.
Prepare For Transport
Care should always be taken to position drum for transport and properly stow
components in the Condux Figure-8 Eliminator Trailer. After cable is unloaded,
prepare for transport in the following way:
CAUTION: Condux Figure-8 Eliminator Trailer is not intended to transport
cable. Cable should be completely unloaded before transporting trailer to
another location.
A. Move drum into Transport position by pressing the Transport Drum key on the
Hand-Held Wired Remote Controller. Drum should be at the far forward position
for transport.
B. Release the arms with the Arm Disengage switch on the control panel.
C. Mount the Arm Lock to the arm housing (Figure 29).
D. Turn off the Arm Disengage switch.
E. Shut engine off.
F. Close Access Doors at sides and rear of trailer.
G.Close Tilt Panels on both sides of trailer.
Figure 29. Mount Arm Lock
Figure 30. Stow Controllers
9.