Filter
Top Products
8 Chapter
■ Adjust the paper guides to fit the width of your document.
■ The automatic document feeder (ADF) can hold up to 10 pages, feeding each one individually
through the fax machine. Use standard (64 g/m
2
~90 g/m
2
) paper when using the ADF; if you’re
using heavier paper, feed each sheet individually to prevent paper jams.
■ Press Resolution (before you send the fax) to select the resolution for the document you’re
sending. If you wish to sent STANDARD resolution, ie a general fax with no graphics, then the
default is STANDARD, and the resolution button need not be pressed.
Making a Copy
See “Making a Single Copy”, step 11 in Preparation and Simple Use Guide (see page 4).
Setting the Dialling Mode (Tone/Pulse)
Your machine is initially set to TONE. If you are using a PULSE dial line, you can change the
setting to PULSE by following the steps below.
1
Press Menu/Set, 1, 1. The screen prompts you to select TONE or PULSE.
2
Use or to select the dialling mode, and press Menu/Set when the screen displays the
dialling mode you want.
3
Press Stop to exit.
• DO NOT use, curled,wrinkled paper, folded, ripped paper, or paper with
staples, paper clips, paste, or tape attached.
• DO NOT use, cardboard,newspaper, or fabric.
• DO NOT use paper on which correction fluid has been used
• Make sure documents written with ink are completely dry.
Do NOT pull the paper while copying is in progress. To cancel, press
Stop
.
Although this equipment can use either Pulse or Tone signalling, only the
performance of the Tone signalling is subject to regulatory requirements for
correct operation. It is therefore strongly recommended that the equipment is set
to use the Tone signalling for access to public or private emergency services. The
Tone signalling also provides faster call set up.
Paper Guides