Brother Personal Embroidery Design Software System Electronic Accessory User Manual


 
13
Installation
System Requirements
Before installing the software on your computer, make sure that the computer meets the following
minimum PC requirements.
Computer IBM-PC or compatible computer
Operating system Windows
®
2000, XP
Processor Pentium III 800 MHz or higher
Memory 128 MB (512 MB or more is recommended.)
Hard disk free space 200 MB
Monitor SVGA (800 x 600), 16-bit color or higher
Port 1 available USB
Printer
A graphic printer that is supported by your system
(if you wish to print your images)
CD-ROM drive Required for installation
Note:
• Power is supplied to the USB card writer module through the USB connection. Connect the USB
card writer module to a USB connector on the computer or to a self-powered USB hub that can
supply enough power to the card writer module. If the card writer module is not connected in this
way, it may not operate correctly.
• This product may not operate correctly with some computers and USB expansion cards.
Step 1: Installing the Software
This section describes how to install the application software.
Note:
If the installation is interrupted or
not performed as described, the
software will not be installed cor-
rectly.
Before turning on the computer,
be sure to DISCONNECT the USB
card writer module.
In order to install the software, you
must log on to the computer using
an account with administrator
privileges.
Insert the enclosed
CD-ROM into the
computer’s CD-ROM
drive.
PED7_QSG.indb Sec1:13PED7_QSG.indb Sec1:13 02.06.2006 20:07:0002.06.2006 20:07:00