Filter
Top Products
1
2
3
4
5
6
7
8
9
65
z TROUBLESHOOTING
Error Messages
When an error message appears on the display, follow the directions provided below.
Error Messages
Press any key to clear the error message.
Message Cause/Remedy
The installed batteries are getting weak.
The installed batteries are about to run out of power. Replace
with new batteries or connect the AC adapter before
continuing.
An incompatible AC adapter is connected. Use only the AC
adapter (Brother AD-24) designed exclusively for your
P-touch labeler.
The tape cutter is closed when you try to print or feed tape
with the cover closed and the tape cassette inserted. Turn the
P-touch labeler off and then on again before continuing.
When tape is tangled in the cutter, remove the tape.
There is no text, symbols or bar code data entered when you
try to print or preview a label. Enter data before continuing.
There is no tape cassette installed when you try to print or
preview a label, or feed tape. Install a tape cassette before
continuing.
The tape cassette is changed while printing, etc. Make sure
the correct tape cassette is inserted before printing.
There are already five lines of text when you press the
key. Limit the number of lines to five.
There are more than three lines of text when you press the
or key while using 1/2" (12 mm) tape. Limit the
number of lines to three, or replace with tape cassette of
larger tape width.