Buffalo Technology HDS-PHU2 Series Personal Computer User Manual


 
3
HDS-PHU2 Series User�s Manual
2
Safety Precautions
This describes the safety precautions for use with this product.
Safety Precautions
CAUTION
Do not perform any of the following, as this can result in a loss
of data.
Setting this device as the save destination of virtual memory.
Removing the USB cable or power cable or turning o the power of the
connected computer while this device is being accessed.
Enabling the power-saving mode (standby, hibernation, or sleep) of the
connected computer. (The device may not resume operations after entering
the power-saving mode.)
After you are done using this device, be sure to disconnect it from the computer.
The device automatically locks when disconnected from the computer. If the computer is turned o or
restarted without rst disconnecting the device, the device may not lock.
If you forget the password, you will not be able access the data recorded on this device, so take
measures so you do not forget the password.
Keep your password secret and do not tell it to others.
In Windows 2000, after the password is authenticated, the [Unplug or Eject Hardware] notication
appears, but the device operates normally. Click [Close] to close the notication. You can continue to
use the device.
In Macintosh, multiple devices cannot be used at the same time.
In Macintosh, install the password authentication software before using the device. (In Windows,
there is no need to install the software.)
In Macintosh, if multiple operating systems are installed, install the password authentication software on
all Macintosh operating systems.
The maximum size for a le stored to a FAT32 formatted hard drive is 4 GB.
This device is formatted as a FAT32 hard drive, so the maximum le size is 4 GB. If you reformat this device
with an NTFS format or Macintosh format, you can store les that are larger than 4 GB
In Windows 2000, the [Found New Hardware Wizard] dialog box may appear during setup. Click [Finish]
on the dialog box.
The [The software for this device is now installed, but may not work correctly.] message appears, but the
device operates normally.