Filter
Top Products
EXAMPLE NETWORKS
86 CyberSWITCH
four calls/connections running in parallel). Configure a dial-out number for the Dallas site, which is:
912143339999. We will not use the remaining parameters (subaddress, profile name or HO support)
for this example. Return to the Device ISDN menu (following), and then return to the Device Table
Menu:
Authentication Information
From the Device Table Menu, select Authentication. Add the Dallas site’s PAP password, which is
dnpswd.
IPX Information
From the Device Table Menu, select IPX. From this configuration menu, insure that IPX routing and
Make calls for IPX data are enabled. You may then enable IPXWAN protocol:
Next, select Routing Protocol. For this example, we will use the triggered RIP/SAP protocol, and
select a WAN Peer Type of ACTIVE:
Finally, there is no need to change the default Spoofing Options. Return to the Device Table Menu.
Device ISDN Menu: (Device = "dallasnet")
1) ISDN Line Protocol "PPP (Point to Point Protocol)"
2) Base Data Rate "64000 bps"
3) Initial Data Rate "64000 bps"
4) Maximum Data Rate "256000 bps"
5) Dial Out Phone Number(s) "912143339999"
6) Subaddress ""
7) Profile Name "Default_Profile"
8) H0 Call Support DISABLED
Select function from above or <RET> for previous menu:
<RET>
Device IPX Menu: (Device = "dallasnet")
1) IPX Routing ENABLED
2) Make calls for IPX data ENABLED
3) IPXWAN Protocol DISABLED
4) Routing Protocol None
5) Spoofing Options
Select function from above or <RET> for previous menu?
3
Use the IPXWAN protocol for this device (Y or N) [default = N] ?
Y
IPX Device Routing Protocol
1) None
2) RIP/SAP
3) Triggered RIP/SAP
Enter selection or press <RET> for previous menu [default=None}:
3
1) Active
2) Passive
Triggered RIP/SAP WAN Peer type [default=ACTIVE]:
1