Filter
Top Products
Chapter 3: Installation
3-10 2E42-27/2E42-27R/2E43-27/2E43-27R User’s Guide
3.4.1.1 2E42-27 or 2E42-27R Cable Connections
Ports 1 through 24 of the 2E42-27 or 2E42-27R are 10BASE-T ports with
internal crossovers. When connecting a workstation, use a
straight-through cable. When connecting networking devices, such as
another bridge, repeater, or router, use a crossover cable.
To connect an RJ45 twisted pair segment, proceed as follows:
1. Ensure that the device connected to the other end of the segment is
powered ON.
2. Connect the twisted pair segment to the 2E42-27 by inserting the RJ45
connector on the twisted pair segment into the desired RJ45 port (Ports
1 through 24) as shown in Figure 3-6.
.
Figure 3-6 2E42-27/2E42-27R Twisted Pair Connection
3. Verify that a link exists by checking that the port RX LED is ON
(flashing yellow, blinking green, or solid green). If the RX LED is
OFF and the TX LED is not blinking yellow, perform the following
steps until it is on:
a. Verify that the 10BASE-T device at the other end of the twisted
pair segment is ON and connected to the segment.
1960-09
13X 15X 17X 19X 21X 23X
2625
13
14
15
16
17
18
19
20
21
22
23
24